Geoff Walliser
Newbie
If that's the case, I wouldn't worry about it. Just leave it there as long as your other mounting holes are centered and not too close to the top or bottom of the frame webs. Your pictures showed the gap on the bottom so, I was going on that premise...
The Belltech instructions say to have the C notch flange in contact with the top of the chassis.
This is what threw me off on the whole thing because I sure wasnt going to torque the bottom fasteners with that huge gap and bend the frame.
It's with this lack of clarity that disappoints me.. tell me to have the top plate on frame in instrucrions but yet the bottom doesn't work out.
Makes more sense to have the bottom flush and tight. You'd leave the spacer out then and just run the gap?
You must be registered for see images attach