PlayingWithTBI
Latest activity Postings About
-
-
PlayingWithTBI replied to the thread Keep Manifolds or get shorties?.Great, you guys will love it! A word of caution, I do get a little drone around 60 MPH with 4.11 gears but, whoever drives that slow... -
This is exactly the exhaust we are putting on my son’s truck.
-
Lifted 2wd trucks and wheel spacers Didn't wanna go to your birthday party anyway...
-
I just posted this in another thread, but since you asked.
-
I saw a truck once with a bed stack exhaust that turned back down and the tip was a shower head, that should probably be on the list...
-
Damn I’m 2 away from bingo with terrible mods.
-
PlayingWithTBI reacted to Scooterwrench's post in the thread Tbi distributor magnet protection from rust question with
Like.
If you remove the ICM be sure to tape off that spot where it sets. The ICM has to have a good ground and be able to conduct heat into... -
PlayingWithTBI replied to the thread Paycheck again at 71?.What's wrong with that? Although I wouldn't wanna be the on bracing the extension ladder, they might get squashed :killer:
-
-
-
PlayingWithTBI reacted to L31MaxExpress's post in the thread Keep Manifolds or get shorties? with Like.
As stated earlier although I used Hooker long tubes, the 94 G10 with the 305 TBI was making 15 ft/lbs more torque and only 7 hp less...
-
PlayingWithTBI replied to the thread Keep Manifolds or get shorties?.IMHO, shorty headers alone may add some TQ/HP but, in conjunction with other free flowing components you'll see a marked improvement...
-
PlayingWithTBI reacted to L31MaxExpress's post in the thread Keep Manifolds or get shorties? with Like.
I never did an A to B dyno test, but removing the manifolds and putting direct fit shorty headers improved my fuel mileage and added...
-
PlayingWithTBI replied to the thread Throttle Body Spacer.That is usually used in conjunction with the 1" base spacer. The pod spacer (we also double up the fiber gaskets to get 1/4" too)...
-
I replaced a PCV elbow on my Luminas with an orange-silicone 90 degree spark plug boot. Seen on the front cam cover, left side of...
-
PlayingWithTBI replied to the thread Throttle Body Spacer.A lot of times you can loosen the bolt on the bell housing holding the lines in place. Otherwise there are (or were) 1" extensions...
-
-
Loading…
-
Loading…
Latest posts
-
-
92 2500 6 lug 4x4 NV4500 built SBC ext cab short box long term build- Latest: Sean Buick 76
-
-
