Crookedaxle
I'm Awesome
I have my driveshaft pulled from the rear end. I pushed it forward to drop it about 3/4" with no problem. I dropped it and have only been able to pull it back a bit over an inch. What's holding it together? It looks like there's a rubber seal cap with a grease zerk in it. The cap just spins on the slip yoke and I can pop it off either. Been pounding the slip yoke backwards with a brass hammer and it ain't budging. 1993 GMC K2500 ECLB 4L80E 454
Looks like this.
Looks like this.
You must be registered for see images attach