Hezsus
Mr. Truck
not sure, it should be in today or tomorrow and i'll post up pics then
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Not sure what thread it was in but I saved the wiring info since I am planning on doing this as well.
Wiring Info
What the wires to the DIC connector do
7 = dark green - RAP Fused Supply
8 = black/white - Ground
9 = drk grn/wht - VSS
10= lt grn/blk - Outside air temp (this should be the only wire out of the cab to the sensor)
11= gray - Instrument panel lamp fuse supply
12= ppl/white - LED dimming signal
13 = NOT USED
14= Orange - constant 12v
15 = Yellow - Class 2 serial data
The connector for the DIC to the large A-pillar connector
7 (DK GRN) = P (DK GRN)
8 (BLK/WHT) = F (BLK/WHT)
9 (DK GRN/WHT) = N (DK GRN/WHT)
10 (LT GRN/BLK) = G (LT GRN/BLK)
11 (GRY) = E (GRY)
12 (PPL/WHT) = M (PPL/WHT)
13 = not used in the DIC connector
14 (ORN) = R (ORN)
15 (YEL) = C (YEL)
The large A-pillar connector to the Radio connector
P (DK GRN) = Radio PIN 9
F (BLK/WHT) = Radio PIN 5
N (DK GRN/WHT) = Radio PIN 16
G (LT GRN/BLK) = outside air temp sensor
E (GRY) = Radio PIN 7
M (PPL/WHT) = Radio PIN 6
13 = not used in the DIC connector
R (ORN) = Radio PIN 10
C (YEL) = to purple ALDL wire (OBD II port)
awesome thanks, I need a picture of the plug now though, I dont have the plug end just the DIC, cant see any numbers on the pin either.