packer0440
Reaction score
128

Latest activity Postings About

    • packer0440
      I assume you are talking about a 14 bolt full float. If that's the case, you can pull the pinion out from the front side and check at...
    • packer0440
      I think that the 3.5" x 13" are usually just dually axles, might have changed in later years not 100%. Slide on drums might just be a...
    • packer0440
      packer0440 replied to the thread 10.5 full float yoke.
      I was about to say this. By far the best method I’ve used. Just put the wheels on the ground and you’re good to go.
    • packer0440
      packer0440 reacted to eran tomer's post in the thread 10.5 full float yoke with Like Like.
      This is what I used eventually.and an old bumper bracket as a holder.
    • packer0440
      packer0440 replied to the thread 88-94 Factory Stereo Info.
      Probably a bad cdm, but it would be odd if not having all 5 bands resulted from failure rather than being the incorrect part. I would...
    • packer0440
      packer0440 reacted to BeXtreme's post in the thread Rod thrown, what now? with Like Like.
      My 97 K2500 with 454 has the rods on it. They run from flat pads under the motor mount onto cast-in pads on the dust cover for the...
    • packer0440
      packer0440 replied to the thread Rod thrown, what now?.
      My 1990 has a 454 with an SM465 trans originally with nearly 300k miles and didn’t seem to have any issues. No cracked bellhousing or...
    • packer0440
      packer0440 replied to the thread Rod thrown, what now?.
      I think I know what you’re referencing. I’ve heard them called “strut rods” but same thing. For what it’s worth, my 1990 4x4 doesn’t...
    • packer0440
      packer0440 replied to the thread Rod thrown, what now?.
      Different oil filter adapter so there is clearance for it. These might still be available but not sure. Might have a slightly different...
    • packer0440
      packer0440 replied to the thread Rod thrown, what now?.
      I think the 350 crossover pipe is the same as the 454. After that the layout might differ but you should be able to reuse that at least...
    • packer0440
      packer0440 reacted to Keeper's post in the thread Transfer case shift knob with Like Like.
      Finally back up front on the floors. So thank you hotrodz06 and packer0440. For cripes sake, the tc shift knobs have been a press...
    • packer0440
      packer0440 reacted to Dropped88's post in the thread Rod thrown, what now? with Like Like.
      I put a pump in my 92 from a 96 and that smooth up how the 454 runs and it'll hold the cone spray pattern when you rev it while watching
    • packer0440
      packer0440 replied to the thread Rod thrown, what now?.
      I think 91 was the last year for the SM465, it got replaced by the NV4500 after that. 1/2 tons are more likely to have the 5lm60.
    • packer0440
      packer0440 reacted to PlayingWithTBI's post in the thread Rod thrown, what now? with Like Like.
      As @Schurkey mentioned, the 94 - 95 7.4L TBI ran smaller injectors at 28 - 32 PSI where, the earlier ones ran bigger injectors at 13...
    • packer0440
      packer0440 reacted to Schurkey's post in the thread Rod thrown, what now? with Like Like.
      Small-blocks (except the now-extinct 400) used neutral-balance dampers and flywheels/flexplates UNTIL the 1-piece rear main seal...
  • Loading…
  • Loading…

Latest posts

Forum statistics

Threads
57,342
Messages
1,257,400
Members
41,672
Latest member
zchead
Top