rzr6-4
Latest activity Postings About
-
-
-
rzr6-4 reacted to GXPWeasel's post in the thread Towing near capacity - medium sized boat with
Like.
So towing within the stated limits of the truck is now unsafe, and illegal? How is the boat coming off the trailer, when it's attached... -
rzr6-4 reacted to GXPWeasel's post in the thread Towing near capacity - medium sized boat with Like.
In the long run (and in this long winded post/reply) I was just posting about how well my/our towing experience was with this truck...
-
You’re lucky to be alive.
-
rzr6-4 replied to the thread Concerning GM 6.2 recall and oil viscosity.If OEM spec is 5w20, then you can have a debate over running that vs 5w30. But if Yota is calling for 0w8 in the Camry, they obviously...
-
I don't know if you've had the pleasure of a 2008 Impala but it's been that way for some time.
-
rzr6-4 replied to the thread Okay! Who's is it!?.I had a friend in high school build one, but I would say it was 6-8" even taller than this. Had it on pivot tires. Was his daily for...
-
Just looking at the arch in the rear springs and the angle they meet the spring hangers, I doubt they will be able to do much springing.
-
Clearly you haven’t read all the posts and I absolutely understood your point on a cab swap. What I didn’t understand was I needed to...
-
rzr6-4 replied to the thread Speedo and tacho both read high.Your speedo could be off from a trans swap but a pretty common one is if the PO did a gearing change in the rear differential. This is...
-
rzr6-4 replied to the thread Towing capacity for modified k2500.1) 90% of laws are dumb, who cares. Unless you kill someone while being CLEARLY OVERLOADED, the odds of a lawyer getting involved are...
-
rzr6-4 reacted to Jeepwalker's post in the thread How much did you pay for your paint job? with Like.
One of these is a pretty quick way to strip down to bare steel. Leaves a nice surface w/o damage...
-
Reminds me of driver's seat from a Suburban parts truck I had years ago. Ruined. Kinda hard to believe they were still driving...
-
rzr6-4 replied to the thread 1994 K1500 with header issue.How much does it hit by? If its close I'd take a torch to it, get it glowing and try to bend it around just enough. I've seen guys cut...
-
IMO it's more about the muffler than the manifold. My LS swapped truck has long tubes and a Magnaflow and it's quieter than I expected...
-
-
Loading…
-
Loading…
Members online
- Tomahawk 309
- Adversary
- 0xDEADBEEF
- Irishnexus
- HotWheelsBurban
- Willgmt400
- Luisc
- rzr6-4
- rumpityZ28
- caw_86
- Johnny 5
- PlayingWithTBI
- termite
- Knuckle Dragger
- printzone
- donaldaeverage
- KCusick81
- Caman96
- Memo14
- Curtis21
- Tommy1234
- MyLast1
- 2k2leenin
- dannycs10
- elundquist05
- carguy1327
- FarmerBent
- OBSthebest
- TX97z71
- Romac2702
- Pinger
- Supercharged111
- whiteaverson
- prfixer
- Clean Stepside
- Joe Dirte
- man-a-fre
- KensKTruck
- strikk
- jtmcq23
- Stumpy
- Jsteel18977
- wcaldwell
- 99 escalade
- 98 Nitro
- peteylen
- dradican83
- Andrews98