-
-
docstoy replied to the thread 92 Suburban acceleration issue.Since you have good power on cold engine and reduced power after engine warms up, I would think you are going from open loop to closed... -
docstoy replied to the thread The problem I can't solve 5.7 vortec.Arr spark plug wires routed correctly and are they separated as this could be a crossfire between the 2 of them
-
docstoy reacted to Schurkey's post in the thread Coolant Temp Sensor IN THE CYLINDER HEAD with
Like.
Who cares about the nail-head/mushroom connector vs. the spade connector on the gauge sending unit? The same molded plastic connector... -
docstoy replied to the thread 1992 Cruise Control Module Discontinued - Where to Source Help.Everything about electrical is a puzzle , that's why GM went to the trouble of creating diagnostic charts and wiring schematics for...
-
docstoy replied to the thread intermittent no start till you cycle the gear shift.I'm with movietvet, linkage bent/adjustment/worn, especially since you have to push on shifter to get key out . Or could linkage be...
-
docstoy replied to the thread 1992 Cruise Control Module Discontinued - Where to Source Help.Salvage yards or a reman from parts store. What's wrong with the one you have ?
-
docstoy replied to the thread Knock sensor guru needed..Didn't the mid 90's model s-10's with the CPI fuel system have knock sensors mounted in cylinder heads ?
-
docstoy replied to the thread PLEASE help 95 k1500.Glad you found problem, thanks for letting us know , nothing more aggravating than having something that's not quite right and having...
-
You need to check to see if you have power at the fuel pump connector. If not, troubleshoot backwards from there.
-
Q: Does the fuel pump run for 2 seconds when you first turn the key from OFF to ON? (No need to continue to the START position. You can...
-
The "Hot Fuel Module" was only used on the Big-Block engines, so far as I know. As said--verify that the fuel pump is ACTUALLY GETTING...
-
docstoy replied to the thread Truck starting problem.Sounds like connections snug but not tight at starter or battery connections.
-
docstoy replied to the thread 1988 k2500 goes into "limp mode" when accelerating going uphill.Pull vacuum line off of egr valve and see if any change, also inspect O2 sensor see if tip of sensor is white, could be silicone...
-
docstoy replied to the thread Won’t restart.Trick will work as long as it's is located at intake manifold, if worried about coolant have shop towel handy.
-
docstoy replied to the thread 91 Chevy 350 Weak spark and cluster issues.Fuel and emissions manual will help you more than I could type all day, go to symptoms for your complaint and it will take you in the...
-
-
Loading…
-
Loading…
Members online
- Wademo
- Erik the Awful
- rosert
- Pedersen383
- aaronb
- rjp6262
- krackenfast
- kskazan
- Rainey01
- Erin
- msarge
- Devon 11
- Direwolf
- Mikes98
- Junior57
- 0xDEADBEEF
- West
- Mindtriped
- FLGS400
- NUTTY81
- Chuck_13
- texasil
- Gmt94
- zetabird
- LGLP Trucks
- man-a-fre
- Charlesteneows
- ctbhess
- AboveTheLogic
- bcarver9007
- Chris253
- msaluta
- RichLo
- Jerryred94silvy
- WAM62
- KrisP
- Mr_Meeseeks
- david1994gmc
- Kejob
- yevgenievich
- seant117
- johnckhall
- verasule
- wasted wages
- Remodelmaster
- Wilecoyote
- 919c2500
- royboyx
- Cunningham Machine
- jd33173