Got an answer - it seems you'll have to modify your bin to show KRs, right now you're seeing irrelevant data.
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Thanks for checking out my log file. I got my adx file from tunerpro's site. That makes sense about the KR data being strange. I used the formula it has and inserted my battery voltage as "x" and sure enough it comes out to the 22-23 KR my logs were showing. I went ahead and removed KR from the data list now that I know it isn't an issue.Here's your BLM history from your ride to work log. It is definitely running rich in most cells, probably due to your stumble issue and your rv cam. Once you fix your stumble you can tune your VE table to get your BLMs closer to Stoich (128 or 14.7 AFR). The PCM can only tune so far but, if your VE table is too far off, it can't get there. Dave w over in gearheadEFI developed an Accel spreadsheet that will help modify your table, but you need to fix your mechanical issues 1st.
You must be registered for see images attach
I started a thread there to see if anyone has a better adx file for your PCM, maybe we can get rid of the KRs...
I haven't tried the water test with the coil yet. I went ahead and ordered an acdelco coil and ICM. Will hopefully arrive in the next couple days. I'll keep you updated on how it runs after swapping them out.There's a table in the bin that will adjust fuel injector pulse width based on system voltage and not for spark but, at 13.1 volts I wouldn't worry much about it. I'm still leaning towards coil and ICM. Did you try spraying the coil with water while idling to see what happens?
Thanks a lot for all this great information. The new coil and ICM should arrive tomorrow so we’ll find out soon if that is the fixI just ran across this today. If you scroll down you'll find some .bin files for your 8625 PCM as well as adx and xdf. And even a wiring diagram! HTH
http://www.gearhead-efi.com/Fuel-Injection/showthread.php?336-16168625-PCM-Information-E6
Did you use break in oil or a zinc additive on the rebuilt for the first 2 oil changes? Did you do that when you changed the cam this time?After many months I finally have a resolution to my miss/stumble at idle! I finally put a vacuum gauge on the truck and idling it would show around 17 inches vacuum but the needle was constantly fluttering over 17. To eliminate a faulty gauge I put it on another truck and the needle was solid when idling. Did some research on the fluttering needle and found some info that it could be a bad camshaft. I suspected the cam for a long time but couldn’t 100% determine if that was the issue with it having less than 40k miles on the rebuilt. Anyways, I changed the cam and lifters to a stock grind this past weekend and after breaking in the cam the truck runs perfectly. Have not put a vacuum gauge on it yet but logged some driving time in tunerpro and my blm is now always close to 128 in open and closed loop. Before 105 was about the highest it would get to. No more fuel smell out the exhaust or black smoke. The old cam didn’t appear to have any abnormal wear but I’m thinking it was worn enough to throw off the computer and oxygen sensor? I’m just glad it’s fixed and I can enjoy my truck again! Thank you everyone for your advice and help on this issue!!