The build of "Wh4t3v3rs"

[Caman96]

 

[Wh4t3v3rs]

Well, it's been at rest for about 30 minutes now and holding 15.74 solid!!!! We have a workable power cell folks!!!

You must be registered for see images attach

 

[Wh4t3v3rs]

So, I have a couple extra bussbars on the way so I can void the jumper wires in the series.....

 

[Caman96]

Just curious, what does it weigh approximately?

 

[Wh4t3v3rs]

Just curious, what does it weigh approximately?

Probably 28-30 lbs without box

 

[Caman96]

That isn’t bad, kinda looks heavier than it is.

 

[Wh4t3v3rs]

Prep work for wiring almost complete. I need to make my 1/0 charging cable, get a little 10ga red to supply my relays, and a small fuse box....

You must be registered for see images attach

 

[618 Syndicate]

Prep work for wiring almost complete. I need to make my 1/0 charging cable, get a little 10ga red to supply my relays, and a small fuse box....

You must be registered for see images attach

They're awful proud of that 1/0...

 

[Wh4t3v3rs]

I bought if at cost from the store, and they buy some good bulk. It's wasn't crazy, but NOT cheap by any means!!!! I have 1/0 ground from the battery to the block, frame x2, and bed/cab. I have 4ga ground jumpers for block to heads and other various grounding points. I have 1/0 charging and several 4ga powers, and 10ga power for relays at the switch panel.

 

[618 Syndicate]

I bought if at cost from the store, and they buy some good bulk. It's wasn't crazy, but NOT cheap by any means!!!! I have 1/0 ground from the battery to the block, frame x2, and bed/cab. I have 4ga ground jumpers for block to heads and other various grounding points. I have 1/0 charging and several 4ga powers, and 10ga power for relays at the switch panel.

Curious, did you land on the alternator from the battery and then to the starter, or go directly to the starter?