I just put my entire front end suspension back together. I put the torsion bolts as close to 34mm as i could according to this service manual instruction.
When everything was on the ground and tightened up, the front is sitting about 1.5 inches higher than the rear, i measured from the bottom of the fender to a same point on the tires. I marked the torsion bolts when i took them off and they appeared to be threaded in maybe a 1/4-3/8 of an inch more then how i reinstalled them. If i tighten the torsion bolts further, will the bars push the control arms further down increasing the front end? It feels like the torsion bolts are just barely threaded into the blocks as it sits now. Its a 1998 tahoe, no body lift or suspension lift on it. Im sure im missing info that would help diagnose why it appears to sit up high
You must be registered for see images attach
When everything was on the ground and tightened up, the front is sitting about 1.5 inches higher than the rear, i measured from the bottom of the fender to a same point on the tires. I marked the torsion bolts when i took them off and they appeared to be threaded in maybe a 1/4-3/8 of an inch more then how i reinstalled them. If i tighten the torsion bolts further, will the bars push the control arms further down increasing the front end? It feels like the torsion bolts are just barely threaded into the blocks as it sits now. Its a 1998 tahoe, no body lift or suspension lift on it. Im sure im missing info that would help diagnose why it appears to sit up high