frito-bandito
8 Lugs + 6 Tires + 4 Doors
Don’t sell it! The driveline angle has to be off causing that.
$350 1999 C3500 CCLB
- Thread starter Dropped88
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Its Definitely off can tell been through this before but this truck has been a total pain in the A. And the djm stuff is a bit junky on that part so gonna try belltech. It also dont help with it being so big that I can't put it on our drive on rack
frito-bandito
8 Lugs + 6 Tires + 4 Doors
Yeah these things are tanks lol
Cleaned factory taillight circuit boards then fresh grease because ive never seen a factory go bad. Just get gummed up and lose contact also went ahead and added LEDs
Other then that its been sitting until my belltech driveline alignment kit gets here next week and hopefully fix my issue
Other then that its been sitting until my belltech driveline alignment kit gets here next week and hopefully fix my issue
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
How do you like this compared to buying LEDs taillights? Do you just buy the bulbs because you've always had good luck with the factory boards?
The bulbs are cheaper and in emergency I can throw a regular bulb back in. Also the led taillights are expensive and usually dont last before the leds start dying
Put spacers on trans and carrier bearing from belltech didnt do rear spring bolt and shims because I dont think my back is ready for that work.
Anyways it was much better then its been but the truck is also been on the back burner because ive been working on my suburban instead. Kinda burned out on truck so its just sitting or drove a day or 2 here and there
Anyways it was much better then its been but the truck is also been on the back burner because ive been working on my suburban instead. Kinda burned out on truck so its just sitting or drove a day or 2 here and there
Small update.
Finally can drive the truck reliably again since in the time it sat the starter solenoid went stupid and would click more often then crank.
And I wasnt about to buy a starter for $150 locally and dont trust cheap junk on internet so i decided to keep the gm starter and replace the sloenoid well can't do that cause can't buy solenoid. So did some research and ford using the same solenoid and you can buy one of them. And I didnt do that either went cheaper lol. Had a good ford starter at work yanked solenoid off and fixed mine for free. Haha
One on right is from ford
Bucket list on truck now is
Valve guide seals for extended idle smoking some times
Valley pan I found leaking when I did starter
Rebuild trans
And finish driveline alignment kit
And maybe just maybe if the money pit would quit with the surprises I could work on making it one color
But on a side note this jewel came into work it's a 1 owner 1999 2 dr tahoe 2wd kinda rare around here. Rest are always 4x4
Finally can drive the truck reliably again since in the time it sat the starter solenoid went stupid and would click more often then crank.
And I wasnt about to buy a starter for $150 locally and dont trust cheap junk on internet so i decided to keep the gm starter and replace the sloenoid well can't do that cause can't buy solenoid. So did some research and ford using the same solenoid and you can buy one of them. And I didnt do that either went cheaper lol. Had a good ford starter at work yanked solenoid off and fixed mine for free. Haha
One on right is from ford
You must be registered for see images attach
Bucket list on truck now is
Valve guide seals for extended idle smoking some times
Valley pan I found leaking when I did starter
Rebuild trans
And finish driveline alignment kit
And maybe just maybe if the money pit would quit with the surprises I could work on making it one color
But on a side note this jewel came into work it's a 1 owner 1999 2 dr tahoe 2wd kinda rare around here. Rest are always 4x4
You must be registered for see images attach
You must be registered for see images attach
HotWheelsBurban
Gotta have 4 doors..... Rawhide, TOTY 2023!
Sweet! I'd like to have one of those. My Burb ' s mini me LOL. Just gotta be a millionaire first......
Good to know about the solenoid. I always said Fords better ideas were somebody else's first!
Good to know about the solenoid. I always said Fords better ideas were somebody else's first!
Its really nice for almost 300k but I doubt they would part ways with it haha
Thats about right ford can take a great idea and turn it in a pos lol
Similar threads
