Tom P
I'm Awesome
So I recently replaced the fuel pump/sending unit in my K3500. I went with a Denso unit because I like their stuff and Its probably made better than the Delco one anyway. Unfortunately I think I may have made a mistake in doing so. Its not a dire issue by any means but it took my fuel gauge from having 5-6 gallons left in the tank on E to having over 10 gallons left in the tank on E. And I'm talking passed the red lines down in to the drawing of the empty tank. It is the correct unit for my truck (double checked that 4 times). I did fix the ground when I replaced the sending unit. The original ground was corroded beyond repair so I drilled a new hole, cleaned up the area with a wire wheel and added new terminal ends and new hardware. I wired in the new harness plug and used shrink wrap on all the connections. I checked for full motion of level indicator and all seemed ok.
Has anyone experienced this before? Thanks in advance
Has anyone experienced this before? Thanks in advance