94Sierra4x4
All out OBS.
Clear coat: strip and repaint.
Rust, sand to virgin metal (leave no rust, not even specs), filler/primer and then hit it with paint.
you must use paint as primer is porous and will allow water and oxygen to make it to the base metal and cause rust all over again. Get a rattle can of matching paint if you're not doing the whole truck until you can swing a full paint job.
Is it just me or does your thumb look all F'd up?
I sliced through the entire tip with an exacto-blade a few days prior lol.. unless your talking about the knuckle.. i was pushing lol.
I think I'll do the entire truck with black plastidip..
So sand down to bare metal, filler, then primer.. then paint?
I guess I'll need to atleast knock down the clear on the entire truck?
Would a sanding block be a good idea?