I just purchased this yoke and seal kit from napa
Everything fit well, my only issue is that the u-joints on the driveshaft are to big for the yoke. The old yoke is trashed unfortunately so using that is not a option.
The website says its a exact fit for a 1994 k1500 4x4. Is it the difference between a aluminum and steel driveshaft?
Mine is aluminum, nv4500 trans, 10 bolt rear end. As far as I know everything is stock. The u-joint caps measure a little over 30mm diameter. Would this work potentially?
Unfortunately I've used the seal so i doubt i can return the yoke at this point.
Everything fit well, my only issue is that the u-joints on the driveshaft are to big for the yoke. The old yoke is trashed unfortunately so using that is not a option.
The website says its a exact fit for a 1994 k1500 4x4. Is it the difference between a aluminum and steel driveshaft?
Mine is aluminum, nv4500 trans, 10 bolt rear end. As far as I know everything is stock. The u-joint caps measure a little over 30mm diameter. Would this work potentially?
Unfortunately I've used the seal so i doubt i can return the yoke at this point.