Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
@sewlow, you're the man for this problem. LolThis rail under the bed sits right on top of my c notch and hits on bumps will cutting off the spot where it hits solve the problem?
You must be registered for see images attach
The 14 bolt (even the 9.5 like yours and the one in my 2500LD) adds challenge to the mix. Larger case, larger axle tubes...I was ready to do pretty much the same thing to my '94; the bump stop pads were smacking the notch on hard dips, but if I made that clearance in the notch, the next thing to hit was gonna be the differential on the bed floor. So the plan was to increase the notch, then cut a hinged flap in the bed floor and laugh every time it clanged.As you see it has to be cut out, I had to go one step further because of 14 bolt rear end the ss454 came with, much larger than the others so I not only had to cut out that cross brace I had to have a little custom piece made for the section of bed I had to remove, low means things like that. I also had the C notch redone because whoever did it prior to me getting the truck did a lousy job so I had and "under bed/over frome" notch done to get any clearance at all. If you want to go low this is the price we pay right
Bobby V
You must be registered for see images attach
You must be registered for see images attach
The 14 bolt (even the 9.5 like yours and the one in my 2500LD) adds challenge to the mix. Larger case, larger axle tubes...I was ready to do pretty much the same thing to my '94; the bump stop pads were smacking the notch on hard dips, but if I made that clearance in the notch, the next thing to hit was gonna be the differential on the bed floor. So the plan was to increase the notch, then cut a hinged flap in the bed floor and laugh every time it clanged.
Richard
Still lookin' great guy. Any update on when you're gonna get that monster stuck under the hood? We need pics!If you want to go low this is the price we pay right