evilunclegrimace
Does not always play well with others
I can't count how many times that I have changed these terminals.Yeah the TPS connector is pull to seat also and they came right out.
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
I can't count how many times that I have changed these terminals.Yeah the TPS connector is pull to seat also and they came right out.
No sir,I'm working with the metri-pack that uses the flat blade tool. This illustration shows going in the front to release the terminal but the FSM says to go in the rear.(hmm,someones gonna have fun with that statement).Your using the round hollow tube tool right? Push the wire up a little, then slide the tube part over the roundYou must be registered for see images attachpin sometimes it's a little harder to get the lock tabs to lay down when inserting the tool. You'll know when the tool dead ends in connector pin hole. Metri-pack only 1 lock tab so blade release tool. Weather-pack has 2 lock tabs , pin is round so use hollow tube tool to release. Left side tool.
No,I'll get you a pic of it tomorrow but the second tool from the left would be the right tool. It's the IAC connector with the four terminals inline.The150 series I use the wider flat blade, through the smaller slot, the seal will make it tight to remove, tip the blade to unlock the tab. Slide out the back.You must be registered for see images attach