-
-
SUBURBAN5 replied to the thread 98 suburban slip yoke help!.If that happens I'll be sure to do that.. this is my daily driver though, makes it kind of hard to take apart and get stuff done lol -
SUBURBAN5 reacted to Canadian Rust Bucket's post in the thread 98 suburban slip yoke help! with
Like.
If you find you have too much grief trying to guess the size, you could pull the driveshaft and take it to a local shop. My u-joints... -
SUBURBAN5 replied to the thread 98 suburban slip yoke help!.Thank you. Of coarse that's not the motor and tranny. But anything that has that mileage is going to be replaced as stated. I agree...
-
Nickel coating refers to the spline wear condition with movement in and out creating excess clearance an annoyance more than safety...
-
So I checked out the cam retard and it is -16.1. I tried moving the distributor and it did not change at all, even after revving it up
-
The P1345 is not likely the cause of misfire and poor performance. It should be fixed, but don't expect improvement unless it's...
-
SUBURBAN5 replied to the thread 98 suburban slip yoke help!.Maybe one of the dumbest excuses I have but I'm trying to get a new yoke to replace my original yoke since it's original and has 505k...
-
I've seen his Burb....
-
You still haven't explained why you need a new yoke. And I don't know what a "nickel" yoke is. Non-greaseable joints are somewhat...
-
I think you need to measure as previously posted. You've never told us what the width of the joint is, just the cap diameter. A 1.063...
-
SUBURBAN5 replied to the thread 98 suburban slip yoke help!.That's what I'm thinking. Turns out gm vin part # match is also wrong. I'll be sure to keep yal updated. I'm gonna roll the dice...
-
Well, looks like I'm wrong. That looks too small to be a 1344 cap to me. Probably a 1330?
-
-
SUBURBAN5 replied to the thread 98 suburban slip yoke help!.Sounds good I'll report back when I get my digital caliper numbers
-
Yup. Especially if it's Amazon you're asking about. They and eBay are both notoriously bad with fitment info in my experience. I...
-
-
Loading…
-
Loading…
