ok, just had an epiphany for people like me who don't smoke or allow smoking in our vehicles.
For those of us that have the 4dr suv's (Suburban, Tahoe, Yukon, Escalade), the ashtray's in the rear doors become trashcans for people. ****** me off when I find trash in it. Years ago someone had the balls to stick gum in it. But what to do w/ them?
W/ todays higher demand of need charging ports, especially on trips, I looking for places to stick some.
So my thought is this: 3D print the top half of the door ashtray w/ a flat top (basically as if the lid was molded in) w/ the mounting clips. drill the hole in the center of the top to mount your favorite usb port & paint to match or leave raw.
For those of us w/ Suburban's:
In the 3rd row seat side walls are 2 ashtray assemblies.
My thought is this: 3D print a flat plate w/ beveled outer edges the same or slightly larger diameter as the ashtray assembly. Then print a 2nd pc to mount to the inside of the panel, this pc would hold the j-clips that the screws would go into. Again, paint to match or leave raw. Drill hole in the center & mount your favorite usb port.