1996 LS400 “build”

[MrPink]

cut them all and get nuts and bolts.

 

[HeavyAsAChevy]

cut them all and get nuts and bolts.

So just cut the studs, drill them out and then nuts and bolts.

 

[0xDEADBEEF]

Get some vice grips and a torch and get them as hot as you can, they'll probably come off then.

 

[HeavyAsAChevy]

Get some vice grips and a torch and get them as hot as you can, they'll probably come off then.

I did torch one of them too, but one is really far up and j can only get it with a long extension.

 

[HeavyAsAChevy]

So, for an update. I got the Y-pipe dropped and the bank 2 catalytic converter cut out. Tomorrow I’m gonna come out and cut the bolts holding the flange in place and drill out the hole. I got some new bolts to put in place. So hopefully with a couple hours of work in the morning, I can finish.

 

[HeavyAsAChevy]

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

 

[HeavyAsAChevy]

I tried getting the nuts off with vice grips and WD-40 with no luck. Time to be very careful with the cutting wheel.

 

[0xDEADBEEF]

I tried getting the nuts off with vice grips and WD-40 with no luck. Time to be very careful with the cutting wheel.

Get a face shield!

 

[Erik the Awful]

...and earplugs or earmuffs!
...and gloves. Ask me how I learned that lesson.

 

[HeavyAsAChevy]

Get a face shield!

I’ve for sure got one. I was using it all day while building some metal handrails with my brothers.