Moe2dippy
Newbie
I recently did a cnotch on my 93 Chevy Silverado, the rear end bent in words, and we straightened it out, but the right side frame rail is uneven what can I do to fix? By the way, I know we did a half assed job.
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
That’s how we got it straight but didn’t straighten all thee way it started raining on top of usGo buy a good used frame at a junk yard and start all over. You could try to straighten it with a jack and 4-5 heavy guys jumping on the bumper.
That’s how we got it straight but didn’t straighten all thee way it started raining on top of us
Where would I place the jack if I was to try that methodGo buy a good used frame at a junk yard and start all over. You could try to straighten it with a jack and 4-5 heavy guys jumping on the bumper.
What about duct tape? Not the cheap stuff!I think the bigger question is: What should he do to reinforce the frame once it's straight?
What about duct tape? Not the cheap stuff!
#joking
I think it’s kaput
I was planning on after straight i weld the whole notch in placeWhat about duct tape? Not the cheap stuff!
#joking
I think it’s kaput