Illbedipped
Latest activity Postings About
-
-
Illbedipped replied to the thread GMT400 - Community Scan Tool.It's a 1992 C2500 -
Illbedipped reacted to Drunkcanuk's post in the thread Can you bleed RWABS with the truck in the air? with
Like.
In the manual for my 91, it says (something like) take that rubber cap off and press it in with a screwdriver or something. Air and... -
It's worth putting your fingers under the EGR (feel the diaphragm) and have someone start the engine. Feel for it lifting up. Even so...
-
Old school trick to bleed abs: If you can pump up and get good pedal, take said vehicle on large gravel parking lot (or 2 wheels on...
-
Illbedipped replied to the thread GMT400 - Community Scan Tool.Thanks Carman96, I am working on two issues this weekend and hope to be complete by Monday. Brake bleed is first and my EGR problem is #2.
-
I’m tapping out, @N9nefingers doesn’t need again, so after @Illbedipped this should be the latest: Raycecar ******* Termite HTownOBS
-
Illbedipped replied to the thread Options for a modest lift / leveling kit. 2WD.Rear drop shackles can be easy but if the leaf spring bolts are stuck, it can take a whole darn day.
-
Illbedipped reacted to slow_c1500's post in the thread Options for a modest lift / leveling kit. 2WD with Like.
I did a 2” coil spacer level and it hasn’t caused any problems, but after 2 weeks, the truck doesn’t even look lifted anymore cause your...
-
Illbedipped replied to the thread GMT400 - Community Scan Tool.I only spent a few minutes to get acquainted with the setup. I'll report my findings In a few days.
-
-
Illbedipped replied to the thread GMT400 - Community Scan Tool.I received the OBD1 scanner and found a couple of things. Code 32 is showing up and getting EGR fault. I need to dig into the details...
-
-
I'm sending this thing out to next on list on Friday. @Illbedipped , shoot me you're address. No real luck ... I show no abs...
-
I think this is how I get added to the list, if I didn't get the latest and someone jumped in between just post a correction...
-
Go back a page or two .... until you see the list. Copy it, or "quote" it and read the posts after the list, adding requested names up...
-
Really hard to say as Snap-On doesn't tell you anything in their scanner guides and you would never know until you connect the scanner...
-
You would remove the GM-1 adapter and put the multi-1 adapter in its place on the scanner. Insert the 12v power cord into the multi-1...
-
-
Loading…
-
Loading…
