Um, this aint right.

[SentandBent4x4]

Hey yall,
I've been searching others forums on this topic. But I found none about this. My truck has that stupid rake, and I didn't want to buy a leveling kit because I'm going to really lift it next year. Anyway, I torqued the keys in two turns each. The right hand side bolt is in pretty much as far as it goes. The left hand one is still an inch and a half out. The ground to fender measurement is the same in each side, and it's sits perfectly fine. Why is it like that, and is it a problem?

 

[Supercharged111]

Not a problem. If you were to remove the keys and put them side by side, you'd see they're likely not clocked exactly the same as one another.

 

[SentandBent4x4]

Okay, tks.

 

[SentandBent4x4]

Should I get new bars? My angels are pretty much flat, and my tbs are in all the way.