Not sure with that sniper,may not read the knock sensor, Did you wire it in?
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
So I checked the wire for the knock sensor and it is not in the sniper so I’ll get that connected here soon but I was driving it at 18 degrees and noticed a difference but something still off so I pulled logs and the configuration and this is the timing table that the sniper made, now like I said I’ve never tuned before but from the research I’ve gathered over the past few weeks, this table is dead wrong, right? Shouldn't those reds be 18 and then the graph smoothen out in the 16, 18, and 25 boxes???You can probably increase your idle timing to 18,liven it up off the line a little. Add a couple deg. at cruise. WOT looks like a good starting point,you can bump that up 2 deg. at a time till you get knock then back it off 4 deg. Your starter will last longer if you back the crank timing down to 0
i bet it runs horrible with that timing mapSo I checked the wire for the knock sensor and it is not in the sniper so I’ll get that connected here soon but I was driving it at 18 degrees and noticed a difference but something still off so I pulled logs and the configuration and this is the timing table that the sniper made, now like I said I’ve never tuned before but from the research I’ve gathered over the past few weeks, this table is dead wrong, right? Shouldn't those reds be 18 and then the graph smoothen out in the 16, 18, and 25 boxes???
Until it hits 2250. Probably runs like 2stroke dirt bike. Bog,bog,bog,,,,,,,Hang On!!!i bet it runs horrible with that timing map
It doesI can’t snap WOT or itll backfire, sometimes it’ll catch itself others it’ll die, and even easing into it will not “drop a gear to disappear” should I make that red area higher timing in a smaller area, I feel like even when I got wide open I’m still on the top right edge of the 0 deg boxesi bet it runs horrible with that timing map
I'm guessing this is the table from the setup wizard?So I checked the wire for the knock sensor and it is not in the sniper so I’ll get that connected here soon but I was driving it at 18 degrees and noticed a difference but something still off so I pulled logs and the configuration and this is the timing table that the sniper made, now like I said I’ve never tuned before but from the research I’ve gathered over the past few weeks, this table is dead wrong, right? Shouldn't those reds be 18 and then the graph smoothen out in the 16, 18, and 25 boxes???
and I did some digging on this and it turns out the sniper doesn’t have a knock input and/or can’t read itNot sure with that sniper,may not read the knock sensor, Did you wire it in?
Whoa! Don't run that! WAY too much advance. Go back and read post #27So I checked this video outxc_hide_links_from_guests_guests_error_hide_mediaand made a base table with my numbers, but idk how this looks and I don’t want it to be stupid and mess something up so here it is