New sliding rear window

[hiredgun8]

According to this they are all the same and are attached with urethane adhesive.

 

[Mschaffer92]

Sweet never even bothered to look in there. Thanks bro

Sent from my camo'ed GS3

 

[firefighter_2319]

According to this they are all the same and are attached with urethane adhesive.

yes they are all put in with urethane, think that started i 87 or 88. piano wire would be your best bet. or if you can get your hands on a heat inductor that works good too. but watch and dont get it too hot cuz you will burn the paint. after you get it out, get a razor blade with a handle and get the biggest part of the urethane off then wipe it all off with a rag, then lay a bead of new urethane about a 1/2" high all the way around. if you run out of a tube in the process, overlap where you left off about a 1/4" and go again until you have went all the way around it. get the back glass and put the bottom in first (easier with 2 people) get it where you want it the top as well and with an open hand smack it down all the way around where it will seal. get some masking tape and go about half way to the glass and a bit on the cab so the tape will hold it in place while it dries. your good to go in about an hour. hope that helped