mars2878
I'm Awesome
If youve got power locks just hit the button?
manual windows & locks on mine, getting all of the necessary parts to swap to power would most likely cost more than adding exterior locks to the rear doors
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
If youve got power locks just hit the button?
That’s what I have planned tm but I’m going to make it adjustable, time dust off my dusty Snap-On tap&die set and get my moneys worth out of it lol!You will need to weld a small washer or something to push down on the latch to replicate the nub that is on the factory rod. The lower straight section goes into a hole in the latch and the nub pushes it when you open the door
That’s what I have planned tm but I’m going to make it adjustable, time dust off my dusty Snap-On tap&die set and get my moneys worth out of it lol!
Sent from my iPhone using Tapatalk
Most definitely, thank you! I am having a hard time determining the angle in the photo below, Everything else is good. A good side shot of the left and right hooked up to the handle would help ten foldAre the measurements helping? If you need more, let me know.
Bending them wouldnt be bad, bending them accuratly would be a pita. Ive got a manual rod bender that would make short work of bending those without a torch but making a replica of them is the problem. If you figure it out though more power to ya, i might buy a set lol
Yea but for a small run, the cost of a jig would kill the profits or make them expensive. Plus measuring the oem lock rod and designing the fixture would take quite a bit of timeMake a jig they fit into to check the angles on the lock rods when bending them. Mount a tab on the jig with a hole for the latch end to fit into (at the correct height and distance) in order to check the angle and length of latch end angle. For those putting locks font and rear, same lock rods should work front and rear shouldn't they? I'm not sure though, I haven't looked at the rear linkages in a while.