help with full float swap

[eran tomer]

i swapped today the full float axle and the old u-joint won't seat fully into the yoke, there's a small gap left bwtween the caps and the mounitng surfaces.
any ideas why?

 

[stutaeng]

i swapped today the full float axle and the old u-joint won't seat fully into the yoke, there's a small gap left bwtween the caps and the mounitng surfaces.
any ideas why?

Do you have a picture? How much gap is there?

 

[eran tomer]

You must be registered for see images attach

You must be registered for see images attach

 

[Nad_Yvalhosert]

Looks OK to me, just tighten it. The strap needs to be "stretched" around the cap, and that's also why the hole is an oval.

Edit: Looking at your first pic, there seems to be a gap at 9-o-clock, just above the nib on the yoke. Use a hammer and tap the u-joint cap in farther,

C'mon Happy! Just tap it in. Just tap it in. Give it a tap tap tappity.

Or tighten the strap as I first wrote, and it will push it in where it's supposed to be, and the strap gap will be gone.