Hi all, I recently replaced the drivers side cab mount bracket, the piece of steel it mounts to, and the inner cab corner. (I will add in LMC truck part numbers) Now, my door will not close properly as it looks sagged, and it closed perfectly fine before my work, and the door closing body lines all around the door are off as well. Any suggestions of what I all did wrong? This project has taken long enough and i am tired of running into issues!
Inner rocker 39-9632
Inner cab corner 39-9658
Rear cab mount support
I also had to “modify” my already homemade bracket as when I put in the rear cab mount support I could never figure out how to get it in level, and so the mount it’s self is sitting at a bit of an angle truly. Any help is greatly appreciated!