bought a truck already lowered

[CJ91C1500]

bought a 91 c1500 already lowered,how do i figure out how much? the rear frame is notched and the axle flip is done idk about the front how could i tell? i need to figure out what size tires to run up front so they wont rub i dont have enough money to do the trial and error impala rims are no longer on it has stock 15 in steel wheels with 225/70/15 on it now

You must be registered for see images attach

 

[Devs93]

looks like a 4/6 hard to tell in the angle

 

[CJ91C1500]

ill get a side view later and post it up is that what you have on the truck in your sig

 

[Devs93]

5/7 ........

 

[supertrucker1978]

Its has to be 4/6. Im at 4/5 on 17's and your front fender gap looks like mine. And your rear is just a tad lover than mine.

 

[1badgmc]

I'm going to say 4/6 as well. It doesn't look low enough for a 5/7, but if you have a flip kit, you're good for 6" out back and since it's level, that would give you 4" up front. It was most likely done with spindles and springs.

 

[trailer-trash]

I like the impala wheels...

 

[94LowRider]

I like the impala wheels...

I'd say 4/6 to, its great when mods are allready done.

 

[bow61509]

I'd say 4/6 to, its great when mods are allready done.

sometimes its great.... but most times mods are done incorrectly and its not too great

Sent from my static android

 

[bow61509]

also OP you said it now has 15 inch wheels does it rub the control arms?

Sent from my static android