I totally agree with you something doesn’t make since, maybe it has lift shackles on it. If you look at
@someotherguy dually his sits perfect. I’ve never used a lowering kit straight from the box on a dually. Kits are like hamburger meat, it’s your base. Then you season it to taste.
Thanks.. I actually think my truck looks slightly sagged in the back, but I know it's just my eyes playing tricks on me because of the lower wheel opening height in the rear fenders. The truck is near dead level, but I haven't actually put measuring tape on it to prove it to myself. I like where it's at and probably won't do anything to change it except possibly putting the lower overload leaf back in at some point.
Pics so you don't have to go look them up:
You must be registered for see images attach
You must be registered for see images attach
The setup on my truck is the Belltech 722SP - spindles and springs up front, flip kit out back, stock shackles. I didn't use the supplied coil spacers in front, so it's the full 5/8 drop. Tires are OEM size 225/75/16 (29.29" tall)
You must be registered for see images attach
You must be registered for see images attach
Youve got a castle nut on a tie rod that looks like it’s upside down and missing a cotter pin. Also brake hoses appear to be awfully close and possibly rubbing.
Looks like a real hack did that install
I have to agree it needs a thorough going-over. The brake hoses on this setup are tricky to get bent correctly so they clear everything, and it's best to double-check once the truck is at ride height, so set it down on jack stands under the LCA's and check the hose clearances again. Putting some gentle bends in the metal portion of the brake hoses is a requirement with this type of drop, because otherwise they will rub and get damaged.
My old '92 ECLB wasn't nearly as bad but when I started digging into it I did find one upper ball joint castle nut didn't have a cotter pin on it, and had begun loosening. That was an exciting discovery.
Richard