He dropped it to 7500, not sure if it's still available. It's a lot of money for a work truck that's been obviously used as such. I think a C&C frame would suit me better.
In more relevant build news I decided to go after my annoying exhaust leak. I'd installed a Remflex mid pipe gasket in 2021 and it did what the Felpro couldn't but it blew itself a couple leaks later that year dragging the trailer to CA. I lived with it until now. Tonight I brought the truck home and wrestled the exhaust out of it. I expected it to be easier as I'd had the down pipes out back in early 2020 and this truck doesn't do winter. It all came out with no broken fasteners, but it wasn't without an abundance of profanity and brute force.
You must be registered for see images attach
Had to separate these from the flanges.
You must be registered for see images attach
Not surprisingly, all but the one with the cat and the fat weld came right out with the angle grinder. The flange for the catted piece came out in 2 pieces. After that though, I think welding it will be just as easy as the rest of them.
You must be registered for see images attach
That's a 3" v-band setup, so the ID of that v-band flange is 3" and the OD is 3.25". All the pipes are flared out to 3" at the flange, makes this so much easier. Plus down the road if I decide to change the cat back I can just use 3" pipe to attach here. Tomorrow I'll shove it back in the truck, tack it together, remove, blow off rust, weld, reinstall for reals. Next on my list of annoyances is tweaking pulley alignment, it's still a bit squeaky with the blower. Worst of all it keeps chewing on my aluminum water pump pulley. I've gotta get that under control.