ls6vettenc
Newbie
- Joined
- Apr 19, 2015
- Messages
- 3
- Reaction score
- 0
Hey everyone. A few years ago, I installed a RC 4/2 lift on my 94 2wd. Since day one, I have had problems with the camber on the front end, with it being a few degrees negative. Ive done the knockouts, and can get it zeroed out, but the camber gets knocked out within a few hundred miles. This past time, I even tacked the cam plates in position, and it still did not hold. I'm frusterated to say the least. Ive installed DJM upper control arms which are used to correct camber, and still am way off. I also installed new moog springs on the front end at the time of lift kit install. Im not sure if the springs are the problem, or if its the spindles themselves. If anyone has any stock 2wd springs they dont need, id love to try them.
I just wanted to see if anyone else has had this problem with keeping the camber in check, and what the solutions was.
Thanks.
I just wanted to see if anyone else has had this problem with keeping the camber in check, and what the solutions was.
Thanks.