StepSide88
Newbie
What did you use to remove the body side molding?
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
The Kenwood KMM-BT328U is sitting here under my desk, and I want to thank @slovcan and @Wh4t3v3rs for recommending it, as well as @Frank Enstein, @AK49BWL, @DerekTheGreat, @618 Syndicate, @OB1214, and @Eveready for their input. I'm going to have to engineer a rear support for it, but installing it is also a goal for this weekend.
It's a "Regency Conversion" truck. Likely it was sold with them. I like the fact that it's a square setup. Any wheel and tire will fit at any corner.Cool looking truck, I like those wheels. Whomever put them on there got the offset right.
Being a conversion truck, I don't think it ever had side moldings. The adhesive I'm removing is from the fiberglass side steps that were long gone when I bought the truck.What did you use to remove the body side molding?
Yeah, it's fairly light, but the only thing I have to support it is the plastic surround in the dash. I'd really like a little rear support.Did you look in the box yet? No rear support necessary.