Search results

  1. 96z71sas

    Running lights

    Has anybody installed the Anzio 111299 headlights they have the running lights on them they are cool but I want them to turn off with the turn signals like they should any ideas how to wire them up
  2. 96z71sas

    Horn button airbag will not come off

    I have 96 k2500 with air bag I wanna clean the horn contacts but I can’t get this dang button out I know u gotta pry up on the studs but it’s stuck in cranking on them no luck what’s the deal any help would be great
  3. 96z71sas

    Fender 96 Silverado

    I’m looking for a driver side fender black only for 96 k2500 any 88-98 truck blazer Tahoe or suburban will work I’m in Pittsburgh pa will drive to meet you I can’t find one anywhere and it will be 260 to paint it and I don’t want aftermarket any help would be greatly appreciated thank you
  4. 96z71sas

    5.7 vortec fuel pressure

    Ok so I know there supposed to be at 55-60 or something mine reads 45 psi and drops to 40 psi key on engine off but it starts and drives no problem now I replaced the spider injector today so it’s not the regulator how is this possible if there not supposed to start under 50 psi I think it’s the...
  5. 96z71sas

    96-98 vortec 5.7 fuel pressure

    Stumbles little when starting very hard in cold weather must cycle key fuel pressure is 55 key on drops to 50 after minute or so 47 psi at idle bad pump or regulator also when u Turk key off after running it goes back up to 55 then drops slowly to 50 looks little wet under regulator but don’t...
  6. 96z71sas

    Fuel pressure test 5.7 vortec

    Does anybody remember how to run fuel pressure test I can’t find a thread I think it’s 55psi key on and should hold steady and 60 while running any help would be great thanks
  7. 96z71sas

    Tourque spec 96-00 upper intake 5.7 vortec

    Does anybody know ware I can find the torque spec and pattern for the upper intake on a 5.7 vortec I have to replace fuel pressure regulator and can’t find this in Hayens thank you for any help
  8. 96z71sas

    Dodge leaf spring on solid axle 28x24

    I got one I’m just stumped on I have 96 k2500 with Dana 44 from 79 f250 now I need new leaf springs I measured 52 inch leafs but there not Chevy those are 26x26 from center bolt these are 28x24 there off a dodge anybody ever heard of using rear leafs off like a ram charger or dodge pickup? I ask...
  9. 96z71sas

    Fuel pressure

    Does anybody know the correct fuel pressure for vortec 5.7 with key on engine off and then running I think 60 psi while running can’t find on here anyway having hard time starting think pump or regulator might be bad thanks
  10. 96z71sas

    Solid axle not straight

    Ok I’ve got a solid axle swap 96 k2500 it’s off 79 f250 Dana 44 I wrecked into a car and at first I didn’t notice but the driver rear leaf spring shackle is bent up and twisted it pushed the frame in ware it mounts also the driver side tire looks to be pushed back 2 inches and the passenger side...
  11. 96z71sas

    Trans ran low And overheated

    Might be a dump question but I was in an accident and trans cooler broke I didn’t realize until I started to slip a little I bypassed the cooler and drove home about 80 miles it went up to 240 degrees and stayed there I added fluid so it shouldn’t of been low after awhile it seemed to lose power...
  12. 96z71sas

    G80 9.5 rear end

    Does anybody know how to identify the rear end without taking diff off? It’s 14 bolt semi floater 8 lug on a 96 k2500 not posi I want posi I think it’s a 9.5 g80? Any help would be great thanks
  13. 96z71sas

    Engine mount

    Has anybody ever jacked engine up by oil pan to change a motor mount? I would use a peice of wood to eavn the load also I can’t find ac delco mounts its 96 k2500 vortec I tried the anchor brand they suck any help would be great thank you for your time
  14. 96z71sas

    Door handle

    Are the 88- 00door handles the same all the way up I want a smooth black one the 96-00 are textured it seems the older ones are smooth any info would be great they look the same but idk if will fit thanks
  15. 96z71sas

    Brake pedal height

    I have 96 k2500 the brake pedal is so much higher than gas I'm pretty tall so I gotta pick whole leg up and bend knee sideways is there any way to ajust this or swap it for different year any help greatly appreciated thanks
  16. 96z71sas

    V Maxx intake spacer

    Anybody tried v Maxx intake spacer? Do you have to do a retune looks like it's good for 22hp 26foot pounds torque I also want to do the mpfi upgrade at same time.
  17. 96z71sas

    Radiator fan shroud

    Anybody have a part number for the fan shroud and the radiator for the 5.7 with oil cooler and trans cooler too mine had a 5.0 in it the rad is too small but I can't just go bigger the shroud isn't wide enuff I'd like to get the bigger one in it thanks for your time
  18. 96z71sas

    P1860 4l60e

    96 k2500 4l60e 5.7l has anyone had a p1860 code? I had transmission rebuilt everything is new I herd it could be ignition switch so I bought a new Delco put in still have code. Will it fry the transmission over time it's lifted on 35s so it's under load what else could it be any help would be...
  19. 96z71sas

    P1860 code 4l60e

    I have a 1860 code and I rebuilt transmission so it's not the tcc solenoid I herd it could be the ignition switch any thoughts on what could throw that code thanks for your time.
  20. 96z71sas

    Oil cooler lines 5.7 vortec 96 k2500

    Anybody ever replace the oil cooler lines on 96-99 k2500 5.7 vortec? I want ac delco lines but can't find part numbers any help would be greatly appreciated if maybe a web site I know the dorman part numbers 625-101 and 625-123 thank you for your time.
  21. 96z71sas

    Evo assist power steering

    Part number 19168825 does anybody know if u need to remove power steering pump to install this bypass my 35s won't turn to park and senseo is bad but they sell this instead any help would be great thanks
  22. 96z71sas

    Ac pressure questions

    96 k2500 5.7 it's 82 out and low side reads 47 psi high reads 210 this seems ok but when I rev engine high goes to 250 but low does not move is this ok. Temp are 55 degrees at idle 44 while driving is this ok any help greatly appreciated thanks
  23. 96z71sas

    Snapped Exsaust manifold bolt

    Hi I have a 96 k2500 5.7 vortec and noticed my Exsaust manifold was cracked so for now I used manifold cement but want headers anyway upon further inspection I noticed two bolts are missing I bet they broke off in the head no leaks but with headers I know that won't fly any suggestions on how to...
  24. 96z71sas

    5.7 vortec to 6.0 swap

    My 96 k2500 has a 5.7 with 4l60e I would like to swap to 6.0 4l80e can't find a thread on this I'm sure some of u have done it any info would be great thanks.
  25. 96z71sas

    Rocker panel replacement

    Anybody ever do these on an ext cab 96 believe it's also called gmt400. The outers are starting to go want to replace but I don't have a welder what do u think it will cost at body shop no paint just weld in just asking I live in Pittsburgh PA if anybody can weld them in thanks.

Latest posts

Members online

... and 2 more.
Total: 1,590 (members: 52, guests: 1,538)

Forum statistics

Threads
64,360
Messages
1,392,106
Members
51,485
Latest member
DonnieBhn

Share this page

Top