I have a 97 LS swapped. Removed PCM and running TermX now. Trucks been done for 1.5 years, but never drive it because it's too hot for daughter. Trying to get the AC going. I'm having issues getting power to my compressor. I have no power going out the light green signal wire. Where does pin 30 go? Originally, I was running that to my compressor, but couldn't get power out of it either. I ended up purchasing an aftermarket setup and trying to integrate the factory AC button.High pressure cutout switch could also cause the issue. It breaks the same circuit that the low pressure switch closes when pressure gets too high. It is possible that it has failed. Installing a jumper in similar fashion to the low pressure switch would bypass it. Best thing to do would be to check for power at the hot terminal of the switches until you find your problem. Broken wire is also possible. You should have unswitched power at pin 30 of the relay, ground on pin 85, and your pressure switch circuit and control head will apply power to pin 86 when the AC is turned on. If all of those check out, it could be between pin 87 and the compressor clutch.
Sent from my XT1585 using Tapatalk
Thanks.