Overhead console...
I have a tan interior, its grey... I'm thinking about leaving it.
Questions:
1) what do you guys run in the front if you don't have a blank piece? I have the A/C controls but don't need them.. If anyone has a blank they would be willing to let go of, let me know...
2) I'm just using self tappers... how long of a screw should I use?
Sun Visors...
They are grey too. I think tan and grey don't look too bad so that's why I'm thinking of leaving all of them grey.
1) I need the 2nd little clip that the sun visor clips into to hold it in place. I only made it home with one. I need it grey...
Pot Belly Spring...
I found an antenna on a 400 with a pot belly spring. It was different than the stock one that had a threaded male end on the antenna.
1) I need to know the thread pitch and size of the antenna so I can buy one of these for it...
^^^That's stock AM/FM antenna
Interior Door Handle Replacement...
1) How is it done? I just have the handle (grey part), not the entire set up
That's all I can think of right now... I'll add pictures tomorrow. thanks guys!
I have a tan interior, its grey... I'm thinking about leaving it.
Questions:
1) what do you guys run in the front if you don't have a blank piece? I have the A/C controls but don't need them.. If anyone has a blank they would be willing to let go of, let me know...
2) I'm just using self tappers... how long of a screw should I use?
Sun Visors...
They are grey too. I think tan and grey don't look too bad so that's why I'm thinking of leaving all of them grey.
1) I need the 2nd little clip that the sun visor clips into to hold it in place. I only made it home with one. I need it grey...
Pot Belly Spring...
I found an antenna on a 400 with a pot belly spring. It was different than the stock one that had a threaded male end on the antenna.
1) I need to know the thread pitch and size of the antenna so I can buy one of these for it...
You must be registered for see images attach
^^^That's stock AM/FM antenna
Interior Door Handle Replacement...
1) How is it done? I just have the handle (grey part), not the entire set up
That's all I can think of right now... I'll add pictures tomorrow. thanks guys!