My 97 sierras cluster insert with the guages on it has started to seperate, its causing the plastic to push against the needles and preventing the needles from moving.
My plan is to remove the needles, remove the insert and clean up both pieces before super gluing it flat again, if anyone has run into this any info is much appreciated.
Also since these motors aren't the stepper variety what's the best way to realign?
My plan is to remove the needles, remove the insert and clean up both pieces before super gluing it flat again, if anyone has run into this any info is much appreciated.
Also since these motors aren't the stepper variety what's the best way to realign?