I took the door panel apart. That bottom section was a pain. The 10-12 factory press melt spots, I used a dremel with sanding bit to "thin" the material out to the point where I could seperate it. I also removed the factory speaker grille. I then used a plastic bone tool to push the fabric in tightly to the groove. I used a strong adhesive to keep in in place in the groove, stretched the material out around all the edges, and glued tightly. Then I used a good epoxy to put the panel back together and coated the old plastic backing in more epoxy "where the spot welds were originally"
Sent from my iPhone using Tapatalk