jaydee1445
Newbie
There are several threads with the pros and cons to using brass fittings to replace the problematic quick disconnect that tends to leak and break. I'm not going to beat that dead horse but share the restricted fitting i have found.
Orginally I used a NAPA fitting but it was 5/8 so I'm going to replace it withAC Delco 15-33220 GM12597484 it is 3/4 x1/2 NPT and has the same 3/8" restriction as the OE QD fitting and is steel.
I confirmed the OE restriction with a drill index 23/64 was a slip fit.
I knew the chance of getting the old on out was slim as it was weeping around the base so I needed an extractor. I was able to find the discontinued Lisle/Napa 3 piece set for $14 on fleabay. NAPA 77-4029 ( If you think you are going to do the fitting I would snap one up while the are still available)
Orginally I used a NAPA fitting but it was 5/8 so I'm going to replace it withAC Delco 15-33220 GM12597484 it is 3/4 x1/2 NPT and has the same 3/8" restriction as the OE QD fitting and is steel.
You must be registered for see images attach
You must be registered for see images attach
I confirmed the OE restriction with a drill index 23/64 was a slip fit.
You must be registered for see images attach
I knew the chance of getting the old on out was slim as it was weeping around the base so I needed an extractor. I was able to find the discontinued Lisle/Napa 3 piece set for $14 on fleabay. NAPA 77-4029 ( If you think you are going to do the fitting I would snap one up while the are still available)
You must be registered for see images attach
Attachments
Last edited: