-
-
Donald Mitchell replied to the thread Anyone Used Dynamat?.I used aluminum back product off Ebay, floor doors back of cab and ceiling. A straight foam product under the dash. Very happy! -
Donald Mitchell reacted to gonzo4folife's post in the thread 5/6 or 5/7 lowering the best kit? with
Like.
its been two years since the post but it does bottom out i do not recommend a 5/8 unless you do a bigger notch -
Donald Mitchell reacted to Erik the Awful's post in the thread Another aluminum head question. with Like.
If I end up yanking the engine from WCJr for Roscoe, those AFRs are the heads I'm aiming for when I build another motor. Yes, the heads...
-
Donald Mitchell reacted to PlayingWithTBI's post in the thread Another aluminum head question. with Like.
These are direct replacement TBI heads kinda like the NLA Summit Racing ones but, more expensive (sold as 1 each instead of by the pair)...
-
IF you're going to get it soaking wet, whether car wash, pressure washer, steam cleaner, etc... I'd suggest you remove it from the truck...
-
That doesn't look too bad. You could probably get away with some carpet cleaner sauce, bristle brush on a drill, and a wet dry vac...
-
-
Loading…
-
Loading…
