new to the fourm and hope to get some help on a new project

[Bushwickbill94]

ahahahahaaahaha i told to to get the cool hex notch.


i dident get much done on this thng last night due to the gas station hot dogs i had for lunch yesterday..... but i was able to finish up the notches and welded some more on the bottom side of the frame. im having a hard time welding over head. i just chaged a bunch of parts on my welder and idk i geuss i need to fine tune it. and i ran out of cut off wheels and sawall blades sooooooooo hopefuly i can get the 4 link tacked up this weekend

 

[DRAGGIN95]

Overhead welding is hard, I turn down my wire speed a little and speed up the welding, gravity sure doesn't help when the weld puddle tries to drip and hang's and look's terrible.

 

[Slow&Low]

Bump. Where's the update pics Kyle, I know there's been progress made.

 

[Bushwickbill94]

well ive been fighting off a cold and i havent had much motivation to get alot done but i at least want him to have the option to take it to tex mex. but we will see i dont wanna rush anything. pics are uploading i got the nex x member made and raised the rear of the gas tank 1 inch. basicly just mapped out the rear and set the axle in place and that sorta thing. the x member has more gussents on it now. and i had to make 10 45 degree cuts with my high speed to make the x member but it worked out good.

 

[Bushwickbill94]

here are some pics. the x member is not fully welded to the truck yet

 

[DRAGGIN95]

Looking good!

 

[Slow&Low]

+1. Can't wait too see it finished.

 

[Bushwickbill94]

thanks. and i just went and picked up some 61/2 inch tube to notch the side of the frame for the bags. so they with sit in the center of the bar and not wanna twist the bar

 

[Bushwickbill94]

more progress

 

[DRAGGIN95]

I like all the gussets!