1994rcsbLS
Newbie
Getting a driveshaft made up. However a question was posed will it fit ?
Th400 to a ford 9”
Spinning 7k rpm and wanting Hp rating 950.
Am told by PST Drive shafts I’d need an aluminum 5” shaft based on the length I need/hp/rpm
Will this have enough clearance ?? Say around fuel tank( stock )
Th400 to a ford 9”
Spinning 7k rpm and wanting Hp rating 950.
Am told by PST Drive shafts I’d need an aluminum 5” shaft based on the length I need/hp/rpm
Will this have enough clearance ?? Say around fuel tank( stock )