justin93
OBS Enthusiast
So my door doesn't like to close flush, it sits out a good 1/2" from the lines it should be pressed against when the door is shut.
I've already replaced the pin lock nuts and bushings on both top and bottom.. and i tried using the sliding hammer to adjust the door strike receiver but have had no luck with fixing this issue.
Its really annoying because while im driving i can hear/see the door moving in and out and you can hear it move on the striker.
I was wondering if anyone else has had similar issues with your doors (driver side in my case) and how you fixed this?
Only picture i have at this moment, you can barely see how its off. It will rattle and move in between the striker and latch with a good amount of play driving me insane inside the cabin of the truck. I can hear wind on the freeway as well when its at its most opened point.
I don't want to just throw more parts at it but i got suggestions that said that the welded door hinge was the faulty part in this situation..
I will get pictures after work but would love to hear your guys experiences with or without luck of fixing it i'd widely appreciate it!
Hope to hear from you guys soon
I've already replaced the pin lock nuts and bushings on both top and bottom.. and i tried using the sliding hammer to adjust the door strike receiver but have had no luck with fixing this issue.
Its really annoying because while im driving i can hear/see the door moving in and out and you can hear it move on the striker.
I was wondering if anyone else has had similar issues with your doors (driver side in my case) and how you fixed this?
Only picture i have at this moment, you can barely see how its off. It will rattle and move in between the striker and latch with a good amount of play driving me insane inside the cabin of the truck. I can hear wind on the freeway as well when its at its most opened point.
You must be registered for see images attach
I don't want to just throw more parts at it but i got suggestions that said that the welded door hinge was the faulty part in this situation..
I will get pictures after work but would love to hear your guys experiences with or without luck of fixing it i'd widely appreciate it!
Hope to hear from you guys soon