sewlow
Bitchin' Stitchin'
A tucked bumper needs to be sectioned in 4 spots.
1 on each side to remove the subsequent overhang & 2 on the front, usually just before the corners, to bring the sides in to match the new gap on the front after the tuck.
Check this one.
I like the way the ends have been flared, with the fenders modded to match.
There's actually a whole lot of mods going on with this front end.
GMC grille with a Chevy grille bar!
Like the valance, but I would of done the opening the same width as the grille.
...and it's purple!
1 on each side to remove the subsequent overhang & 2 on the front, usually just before the corners, to bring the sides in to match the new gap on the front after the tuck.
Check this one.
I like the way the ends have been flared, with the fenders modded to match.
There's actually a whole lot of mods going on with this front end.
GMC grille with a Chevy grille bar!
Like the valance, but I would of done the opening the same width as the grille.
...and it's purple!
You must be registered for see images attach