Sramos03
Newbie
Hello fellas wanted to get some advice. I am currently trying to install a bumper on my truck so I can pass a level 3 inspection since I was in an accident and it has been deemed salvaged. I installed new bumper brackets however when attempting to install the new bumper I noticed that the holes weren’t matching upon further inspection I realize that the frame is bent from the driver side the passenger side brackets fit fine. What can I do in order to install the bumper and make sure it’s safe with the bent frame, since currently only the two brackets on the passenger side were able to be bolted down? Any guidance or help would be much appreciated as always thank you.
Attachments
-
A18F6FF1-C644-4F1B-93FB-4D7845C4CF0E.jpeg314.4 KB · Views: 40
-
21309442-D624-4391-8FAF-4E979B9CB2F3.jpeg752.2 KB · Views: 40
-
C5F81BE6-387B-4243-8BEA-AC33E78A1462.jpeg350.3 KB · Views: 39
-
83D92941-41B2-4137-A20B-89EDE741F47F.jpeg294.4 KB · Views: 37
-
19767361-63F2-4058-A61D-FC53A161CC1E.jpeg294.9 KB · Views: 38