Search results

  1. qukon 95

    louder bolt on muffler

    has anybody installed a bolt on muffler that's a little louder than the stock muffler mine has a hole in it.95 yukon
  2. qukon 95

    code 32

    has any body had this code and fixed it. the light only comes on when on highway,i've checked the egr valve with truck running push up egr diaphragm the motor changes the idle plus it moves when i move the throttle by hand.
  3. qukon 95

    still little arcing

    replced the delco wires with 8mm accel wires still have some arcing going on not much but it's there:banghead:
  4. qukon 95

    GOT ANOTHER ONE

    Went to the jnk yrd today to get the driver rear tire jack mount bracket and i didn't know the white suv i cut it out of was a escalade lol ... because i came up from the rear and didn't see the sides of the truck until i had to go back to my truck to get my sawzal i came back but pass the row...
  5. qukon 95

    the bose sub

    sinse i installed the esky console in my truck it has the bose sub in it i used my little kenwood amp and i was really suprised on the bass output from this sub then the amp shut down it can't handle the 1 ohm load. I did put a toogle switch in the consloe so i can switch between the 2 amps...
  6. qukon 95

    fire fire

    monday morning my yuk stoped running while sitting at a light and i was able to coast down to a parking lot (thanks to the )police that stopped traffic i popped the hood and seen smoke what the (hell) had a small fire at the coil i just rplaced the wires 2 weeks ago i know i didn't have any...
  7. qukon 95

    my alarm upgrade

    i ordered the presige ss 9000 1 mile range..... but i got a email 2 weeks later saying that it's not in stock so their going to send me the code alarm ca6551 sst 1 mile range which is a better deal for $169.00 it lists for $ 184.00 on ebay. i'm taking my old alarm off to put on the wife car...
  8. qukon 95

    parts replaced

    sat i went to get a wheel aligment they said i needed a steering gear box &idler arm i told them i just changed them 5 months ago so sun i changed gear box,idler arm & chassis mount,pitman arm,the round rubber (thats over looked) at the end of the steering wheel it was real soft, changed my...
  9. qukon 95

    wiper squeak gone

    got rid of my squeak that i thought was the wiper blades took the crowl off and seen that the linkage was rusty. i put bearing grease in the linkage and on the shaft no more squeaking.
  10. qukon 95

    new rotors

    just ordered a pair of drilled/slotted rotors & ceramic pads hope there is a improvement like they say.
  11. qukon 95

    95 'S ONLY SORRY 94

    :popcorn: YOU can change your big old ash tray to the newer style in the 96 -99 it's a direct fit. And i change my mirror to the temp/compass got lucky in the junk yard and it works good temp is off by 2 degres. you will have to get the wiring out of the truck 96 to 99. are yrs...
  12. qukon 95

    exterior parts painted

    heres some parts i painted. the door visors, the crowl,wiper arms, mirrors,the bug sheild i need to replace got cracked.
  13. qukon 95

    do you have all the lights working

    do you have all the lights working in the interior? just in case the head light switch control panel has a bulb in it i replaced mine with a l.e.d bulb still have to change the ac/heat panel bulbs. and just to rub it in:gr_grin: l.e.d superbrights. com is 25 mins from where i live...
  14. qukon 95

    ALL 94 & 95

    IF you want to add a batt on the driver side under the hood go to your junk yard and find a 96 to 99 they will have the batt tray,the bracket for the canister that will mount on the side and a bonus the washer fluid container that goes under the batt tray. you will have to move the horn...
  15. qukon 95

    my system

    kenwood 929 deck, 2 4 ch kenwood amps 2 2ch kenwood amps bridge 500 rms, 1 old small alpine amp 4 my center spkr ,2 12" cerwin vagas v-maxes,6 1/2 kenwood coponets in the front doors,a pillard 3 1/2 earthquake coxials,6x8 kenwoods coxials in the barn doors, 5 1/2 kenwoods in the rear...
  16. qukon 95

    installed H.I.D reverse lights

    had a set of ddm h.i.ds that i took out of my high beams. a guy did it on T Y FORUM so thanks to him i did it to. i put them in my L.E.D TAIL lights didn't do any drilling holes it about 4 hrs now i did put a relay for them using the light green reverse light wire to trigger the relay so...
  17. qukon 95

    new here from st.louis

    hey fellas!! new here i can't wait to share the things i've done to my yukon and things that you all have done to yours.
Top