"Thank you for the inquiry. We do appreciate our customers sending us ideas for new products and getting feedback on current products. In the past, we have looked into the possibility of making these caps in clear. The high grade of raw material needed to make a superior strength compound does not allow it to be clear. We could use a cheap plastic type material that does not have the dielectric properties required for this cap, but putting out an inferior product is not our MO. Also because of the complexity of the cap and the construction of the tooling, air bubbles form in the material during the injection molding process. This would render the cap defective after a short time.
Thank you again for the inquiry and we do appreciate your support of United Motor Products."
Thank you again for the inquiry and we do appreciate your support of United Motor Products."