sewlow
Bitchin' Stitchin'
These brand newPOS Napa tail light circuit boards have been pissing me off. They are junk. So I just did the stop/tail/turn mod a little differently than most.
I cut a board out of 1/8" ABS sheet stock on the CNC and used 96-98 Grand Am tail harnesses to hardwire my own. Cut the circuit board plug off and crimped, soldered & heat shrunk the connections and taped it all together. Plenty of wire to remove the tails and get to the lights. I'm happy.
I'm going to cut another board with the keyway for a headlight bulb in the reverse spot and see if I like it. I can run it with a relay to take the load off the wiring, but it might not even need it considering the short amount of time the reverse lights are generally on for...
You must be registered for see images
You must be registered for see images
You must be registered for see images
You must be registered for see images
You must be registered for see images
I'd be very interested in a set of those boards, too!