99xcss4
92g-94c frank'n (truburban) K-2500
I have heard read some people say set either 4 degrees advance or 4 degrees retarded where did that come from
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Show him the Factory Service Manual?I ask because I made him watch this and he is still not buying itxc_hide_links_from_guests_guests_error_hide_media
92 C-1500 extended cab short bed 350
Paint a stripe lengthwise on the upper part of the pushrods, so you can easily see that they're spinning when the engine runs. I have been known to sacrifice some Treasure Yard valve covers to make viewing windows for this purpose. This can be part of the first ten-minute run time. (Pontiac covers shown.)guy ordered a crate engine I have a part 2 to this question the instructions say on first start up to hold rpm between 2100 and 2500 rpm for half a hour to break in the flat tappet cam should we do that first or base timing first
7.4L get timed officially at 4 degrees advanced. Small-blocks are officially timed at "0", but lotza folks add a degree or five of advance, and seem to have good results.I have heard read some people say set either 4 degrees advance or 4 degrees retarded where did that come from