ddaxe
If it don't go... chrome it..!!
Being that I did have.. and couldn't get an original bellhousing meant I had to get an older type BH with the clutch fork on the drivers side. That opened another slew of problems to over come. I kept pondering whether to go with an internal or external slave, though once I stumbled upon a "pull" type hydraulic slave I knew that was the way to go so my attention turned to how and mount it. I knew I could make a bracket mounted to the tail housing to main case bolts. Fabricating 3 pieces from 1/4" plate and a stub shaft machined in the lathe, I welded them together to what you see here... Next step is to fab up an inspection cover then I can get to installing the trans...
Sent from my iPhone using Tapatalk
You must be registered for see images attach
Sent from my iPhone using Tapatalk
Last edited: