W
Reaction score
42

Latest activity Postings About

    • W
      WICruiser-97 replied to the thread 97 stumbles when cruising.
      If the problem comes and goes it is not likely a sensor as they tend to fail and not recover. Distributor gear wear could easily cause...
    • W
      WICruiser-97 replied to the thread 1990 Sierra Baffled.
      Look at the circuits that shut off the fuel pump. There was a debate here about if the oil pressure circuit can cut off power to the...
    • W
      What parts did you transfer over from the old engine to the new? For the starting issue look closely at the battery calbe that run to...
    • W
      Sorry, I should have posted a follow-up. I did find a replacment module. It was from old dealer inventory (new in the box). It took a...
    • W
      WICruiser-97 replied to the thread 97 stumbles when cruising.
      Can you determine if it is an engine misfire induced stumble vs. drive train influenced engine reaction? My '97 has a less severe...
    • W
      The A1 I was referring to was the ECM not the fuel pump relay. I am not familiar with the RPM signal providing power through the ECM...
    • W
      Your diagram does not tell the whole story as the A1, B1, and B2 are part of a control module (ECM). The description cut off at the...
    • W
      WICruiser-97 replied to the thread Trucks lacking power.
      If the cat is falling apart it can easily plug the exhaust system creating back pressure and reducing power. Given it is already...
    • W
      WICruiser-97 replied to the thread Nv3500 swap.
      Swapping from an electronic automatic to a manual transmission is a big task. Beside all the changes related to the engine to...
    • W
      WICruiser-97 replied to the thread Spider Question.
      When I looked at the injector systems I also saw the two differnt tube diameters but I thought one was the original spider poppet...
    • W
      WICruiser-97 replied to the thread HELP?!?.
      Not familiar with the 91 4.3 V6 but it looks like a capacitor and I suspect it is tied into the ignition coil, probably to eliminate...
    • W
      You may want to check the engine mounts. If the engine is moving around under torque some strange things can happen and they are not...
    • W
      WICruiser-97 replied to the thread Missfire - cylinder 4.
      I did not replace O2 sensors but I can plug in my OBD reader and evaluate them on the fly to see if they are acting lazy. I did note...
    • W
      WICruiser-97 replied to the thread Missfire - cylinder 4.
      Replaced the EGR gasket but no real change in performance. I did check and the only code set was related to the EGR and it was cleared...
    • W
      If you are going to tear it down to the short block go a little further and tear it down completely. Have the block checked and if...
  • Loading…
  • Loading…
Top